Tapered the legs...

I got up early this morning to taper the legs. I wanted to have them kind of curve and taper, but they're a little to small for that. I ended up just going with a straight taper. I tried to make a simple table saw tapering jig, but that was going to turn out to be a bunch of work. So, I did a quick band-saw tuneup and cut the taper. The first cut didn't go as expected. At first I thought I had hit a really hard knot. Turns out the drill press was in the way. Mistake #221. After moving the drill press, the tapers went fairly quick.

Unfortunately, at this point I got pretty into what I was doing and forgot to take pics. Basically, I cleaned up the horrible bandsaw job I did to get the tapers. I used my No. 7 plane and got it down nice and flat, then I took my cabinet scraper and cleaned up the transition. They're by no means perfect, but they'll do.

Once I finished the cleanup, it was time for quick sanding and a glue up. Again, I was on a roll so the only picture of the entire leg & apron glue-up that I have is the one you see here.

While I was letting the glue dry I did a final sanding on the cabinet. I progressed from 100 up to 220 grit and put a 2lb cut of shellac on the cabinet, then set it outside to sun dry. Worked pretty well.